Directions for Use:
Turn off and unplug device.
Apply a drop amount to contact/connector surface.
Operate the part/device to help distribute the D100 to break up oxides and contamination.
Re-apply a drop to metal surfaces and wipe off excess. It is important to wipe excess, with a lint-free swab or cloth as only a thin coating is required on surfaces.
Wait 2 mins before turning equipment on.
In extreme cases (severe oxidation or corrosion), you may need to leave D100 on overnight. If that is necessary; apply, then the following day remove any contaminants lifted by D100 with a lint free swab or cloth on accessible surfaces (If surface is not accessible, repeat as above).
When surface is clean (no residue showing on the swab/cloth), finish with a dab of D100, then remove excess leaving a thin layer.
If you notice a green or black colouration on the surface (may take a few days) after applying, this indicates dissolved oxidation and contamination (surface was severly oxidised/contaminated) follow steps above.
For severe environment protection: After surface is clean, apply Deoxit Shield S100L-2C (see my other items) for outdoor and severe environments (humidity, salts, pollutants, sulfur, etc).